HOME/MODIFICATIONS/Zex nitrous kit installation
Step 3: Mounting The NMU (Nitrous Management unit)

You now need to find a place to mount the Zex Nitrous Management Unit (the sweet looking purple box.). The tubes that came with the package are way too short to mount the NMU anywhere but very close to the intake. I have an Injen intake which made it very easy to mount in the position in the pictures, however a stock intake may have trouble.

You can mount the NMU anywhere by simply buying longer stainless steel cables. The tube lines cost about 75 cents a foot and you will need 2 of 5' foot tubes.

Once you finish mounting the NMU you are ready to go to the next step.

Step 4: Finding your Fuel Regulator and Throttle sensor

Finding these two sensors is a bitch. This is why it took me so freaking long to install my nitrous kit....

Fuel Regulator
	Ok let's start with the fuel regulator. The fuel regulator looks like a mushroom top. If your car has a lot of mileage it will be rusted it will have one mini tube coming out if it. Compare it to the tube Zex give you...its smaller then that... Pop the stock tube off and follow the lines up to the intake those are where the 2 tubes are going to connect to.
Throttle Sensor
The throttle sensor is located directly behind your actual throttle. It should be a plastic harness with 4 wires coming out of it (RED BLACK/WHITE BLUE/WHITE BROWN/BLACK WHITE). The throttle sensor wire is the BLACK/WHITE wire. This wire will connect the white wire on the Zex NMU so when you floor the pedal...the nitrous will activate.

The next step...