Zex Nitrous Bottle Warmer Install
By Wizard

The bottle warmer comes with only 2 wires red and black. Black connects to the ground and red connects to the switch. I mounted the switch on the left of my radio.

Installation:

1. Disconnect negative battery cable
2. Drill a 1/2" hole for the switch. I mounted mine to the left of the radio.
3. Connect a length of the red wire to one terminal on the switch. Connect the other side of the wire to the powersource. (read install instrucitons limitations)
4. Mount the switch
5. Use the remaining red wire to connect to the bottle warmer and connect it to one of the black wires on the bottle heater.
6. Attach the black ground wire to a ground on your car
7. Reconnect your battery
8. Test the heater
9. Install the heater onto the bottle

and you are done...its that simple

Remember to read the manufacturor's precautions and instructions that are included with the bottle heater before you use it to verify that the everything is correct.

Note: The webmaster takes no responsibility regarding damage or any negative outcomes caused by using the information contained in this article. The information is provided as-is, with absolutely no guarantee it is correct or accurate. All risk is assumed by the reader. Opinions and alleged "facts" expressed in this website represent those views of the particular member who expressed them only, and are not representative of other members or the webmaster.